is will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and rHere is a wet fly-fishing tip that many fly fishermen overlook when nymph fishing lakes and deep pools of rivers and streams using a sinking tip fly line or a sinking fly line. In this example we are fishing a #6 black bunny leech. Because of the way it is tied, like most good wet flies these days, it requires a precise stop and start action to really be effective. The fly must stripped and paused, or what I call the “stop and go” method of nymph fly fishing. For example, cast out your fly and line, and use the fly line sink rate and the count down method (1001,1002…etc) to let the fly sink into the strike zone. Then make one pull in (or strip in) and stop. This allows the material on the fly to open while the fly sinks for two or three seconds then strip again closing the fly, pause, and strip again. This will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and roing a #6 black bunny leech. Because of the way it is tied, like most good wet flies these days, it requires a precise stop and start action to really be effective. The fly must stripped and paused, or what I call the “stop and go” method of nymph fly fishing. For example, cast out your fly and line, and use the fly line sink rate and the count down method (1001,1002…etc) to let the fly sink into the strike zone. Then make one pull in (or strip in) and stop. This allows the material on the fly to open while the fly sinks for two or three seconds then strip again closing the fly, pause, and strip again. This will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and rat I call the “stop and go” method of nymph fly fishing. For example, cast out your fly and line, and use the fly line sink rate and the count down method (1001,1002…etc) to let the fly sink into the strike zone. Then make one pull in (or strip in) and stop. This allows the material on the fly to open while the fly sinks for two or three seconds then strip again closing the fly, pause, and strip again. This will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and rke zone. Then make one pull in (or strip in) and stop. This allows the material on the fly to open while the fly sinks for two or three seconds then strip again closing the fly, pause, and strip again. This will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and ris will cause the fly to rise, fall, open, close, rise, fall, and look alive as you strip in the fly line. To really get the proper action from the bunny leech or any wet fly, you must point the rod and rod tip right at the fly line where it goes into the water while you are stripping in the fly line, otherwise, you don’t get the desired stop and start action. Visualize this, if your fly rod is parallel to the water during the strip, the rod will flex down, and during the pause the rod will flex back up, resulting in the fly just moving along at a study pace without any stop or start action. Again, point the rod down and right at the fly line where it goes into the water.

When using larger wet fly or nymph patterns, make longer strips with a longer pause, and when using small fly patterns, try to make a short strip in and a short pause between strips. Try different combinations of strips and pauses until you find a combination that works for the fish and water conditions that are present where you ar